Laser cutting machine is a commonly used cutting machine in the processing industry. If the equipment breaks down when working, it is very dangerous. Novice must be trained by professional personnel to operate independently. According to experience, 13 details of the safety work of laser cutting machine are summarized:
1. Observe the general safety operation regulations of laser cutting machine. Start the laser in strict accordance with the laser startup procedure.
2. The operator must be trained to be familiar with the structure and performance of the equipment and master the relevant knowledge of the operating system.
3. Wear labor protection articles as required, and wear protective glasses that meet the requirements near the laser beam.
4. Do not process a material until it is clear whether it can be irradiated or heated by laser, so as to avoid the potential danger of smoke and steam.
5. When the equipment is started, the operator shall not leave the post or entrust others to be in charge without authorization. If it is really necessary to leave, the operator shall stop the machine or cut off the power switch.
6. Keep the fire extinguisher at a place within easy reach; Turn off the laser or shutter when not processing; Do not place paper, cloth or other inflammables near the unprotected laser beam.
7. If any abnormality is found during the processing, the machine shall be shut down immediately, and the fault shall be eliminated in time or reported to the supervisor.
8. Keep the laser, the bed and the surrounding area clean, orderly and free of oil, and stack the workpieces, plates and waste materials according to regulations.
9. When using gas cylinders, avoid crushing welding wires to avoid leakage accidents. The use and transportation of gas cylinders shall comply with the gas cylinder supervision regulations. Do not expose the cylinder to the sun or close to the heat source. When opening the bottle valve, the operator must stand at the side of the bottle nozzle.
10. Observe high-voltage safety regulations during maintenance. Maintenance shall be carried out according to regulations and procedures every 40 hours or every week, every 1000 hours or every six months.
11. After starting the machine, manually start the machine tool at low speed in X and Y directions, and check whether there is any abnormality.
12. After inputting the new workpiece program, it is necessary to run it first and check its operation.
13. When working, pay attention to observe the operation of the machine tool to avoid accidents caused by the cutting machine out of the effective range of travel or the collision between the two machines.
The laser cutting machine manufacturer told the majority of new and old users that safety measures should be taken when operating the equipment, keeping in mind the detailed operating procedures, and avoiding accidents. Because this equipment is a high-precision instrument, we should pay more attention to this aspect when using it. I hope that the content explained in this article will help you.
