The lens of laser cutting machine is an important part of optical fiber laser cutting machine, which has the characteristics of high precision and high price. The focusing lens of laser cutting machine is a relatively precise optical element, and its cleanliness directly affects the processing performance and quality of laser cutting machine. Therefore, it is very necessary to maintain the focusing lens regularly. Now, the Redsail laser editor will share some tips for maintaining the focusing lens.
Tips for lens maintenance of laser cutting machine:
1. Take out the focusing lens from the lens frame: loosen the fastening screws and take down the air nozzle and the lens barrel in turn; First, use the blowing balloon to blow away the dust on the lens surface;
2. If the lens really needs to be cleaned, only a laboratory grade paper soft cotton ball can be used, dipped with an appropriate amount of acetone or high retention alcohol, and gently rotated clockwise from the center of the lens to the edge. Both sides of the lens need to be cleaned when necessary, and they should be carefully scrubbed;
3. Install the lens barrel and air nozzle, adjust the focus, tighten the fastening screws, and ensure that the convex face is downward when installing the focusing lens.
The following three points should be paid attention to when maintaining the lens of the laser cutting machine:
1. The focusing lens is made of ZnSe (zinc arsenide), which is brittle and is afraid of falling; Attention shall be paid during disassembly: do not use too much force or collide with hard objects. There is an antireflection film on the surface, which is afraid of pollution, moisture, oil and scratch; Therefore, it is required to provide dry and degreased air during work. Never handle the lens of the laser cutting machine focusing lens directly by hand, because skin grease will cause permanent damage to the lens surface. On the contrary, you can wear gloves and special sets for operation. For smaller lenses, it will be more convenient to use optical tweezers or vacuum tweezers. No matter what method is used to clamp the focusing mirror of the laser cutting machine, it can only be clamped along the non optical surface, such as the frosted edge of the mirror plaque.
2. In general, the focusing lens of the laser cutting machine should be checked before use and before and after cleaning. Because the size of most contaminants and surface defects is relatively small, we often need to use magnification equipment when checking lenses. In addition to amplification equipment, sometimes we also need to use a relatively bright light to illuminate the optical surface to enhance the specular reflection intensity of surface contaminants and defects, so that pollutants and defects can be found more easily.
3. When cleaning the focusing lens of a laser cutting machine, always use clean wiping paper and optical grade solvent to prevent damage by other pollutants. Wiping paper must be moistened with appropriate solvent, and must not be used dry. In consideration of softness, the available wiping paper is pure cotton Webril wiping paper or cotton ball, lens paper, cotton swab and other applicators.
The focusing lens of the laser cutting machine is a consumable. When it still cannot reach a very high cleanliness after many times of cleaning, it should be replaced to ensure the processing efficiency of the laser cutting machine, so as not to delay production.
