This video is about the Machine Origin, Job Origin and Start Location when using Co2 Laser Software. The Laser software I use is Lightburn. Now I know that not everyone uses Lightburn Software so towards the end of the video I will briefly explain where to find these settings in two other Laser Software Packages […]
In this video I show you how to install the Ultimate Air Assist Components from Cloudray Laser on a Co2 Laser using a Ruida RDC-644X Controller. The components for this can be found here https://mwlaser.com.au/product/ultimate-air-assist-kit/ This is an awesome addition to the machine, I have recently purchased a second one for the Laser Machine I […]
This video explains the installation of the Z-Axis Focus Sensor from Cloudray Laser. https://amzn.to/2Jo9m5B .This sensor for the Co2 Laser is used with controllers capable the Auto Focus feature. It can only be installed on a machine that has the work table controlled by the z-axis controls on the laser control panel. In this video […]
COMMON PROBLEMS OF CO2 LASER POWER AND TROUBLE SHOOTING CO2 laser machine is widely applied into laser engraving and cutting. It mainly consists of luminous system, motion system and control system. Today, we introduce the judgment and elimination of CO2 laser power problems. 1. Laser head does not emit light when working First situation, check […]
Is it worthwhile replacing the Air Pump which was shipped with your Co2 Laser Machine, with an Air Compressor? Will it improve the results from your laser machine? Aren’t Air compressors extremely noisy, I don’t want all that noise in my workshop? To address that last question 1st, no not all air compressors are noisy, […]
In this video I install a mA Meter (ammeter / milliamp meter) on a Co2 Laser. This is a simple process that requires care and knowledge of your system! WARNING (See 0:28) I Recommend a 0-30ma ammeter for Co2 Laser tubes up to 80W – https://mwlaser.com.au/product/cloudray-30-50ma-ammeter/ A LIST OF UPGRADE PARTS I USED CAN BE […]
There are many times when we all experience poor cut quality from our Co2 Laser machines. It may be all running well one day and then the next something has changed and you cannot seem to get a good quality cut. If you are not getting a good quality cut on your machine, this short […]
