The current laser cutting machine is a large-scale mechanical equipment. The price of a laser cutting machine ranges from hundreds of thousands to hundreds of thousands. The ultrahigh power laser cutting machine is more than a million. In order to make it work better, professional personnel must be equipped to operate it. They must have the operating knowledge of the laser cutting machine. Before operation, they should do the corresponding training and strictly follow the safety operation specifications of the laser cutting machine, Now let’s introduce the precautions of laser cutting machine in daily use.
1、 Follow the safety operation regulations of laser cutting machine. Start the laser strictly according to the laser startup procedure.
2、 Wear labor protection articles as required, and wear protective glasses that meet the requirements near the laser beam.
3、 The operator must be trained, familiar with the equipment structure and performance, and master the knowledge about the operating system.
4、 When the equipment is started, the operator shall not leave the post or entrust others to be in charge without authorization. If it is really necessary to leave, the machine shall be shut down or the power switch shall be cut off.
5、 Before knowing whether a material can be irradiated or heated by laser, do not process it to avoid the potential danger of smoke and steam.
6、 Keep the fire extinguisher within easy reach; Turn off the laser or shutter when not processing; Do not place paper, cloth or other flammable materials near the unprotected laser beam.
7、 In case of any abnormality during processing, stop the machine immediately, eliminate the fault or report to the supervisor.
8、 Keep the laser, bed and surrounding area clean, orderly and free of oil stain, and stack workpieces, plates and waste materials as required.
9、 When using gas cylinders, avoid crushing welding wires to avoid electric leakage accidents. The use and transportation of gas cylinders shall comply with the gas cylinder supervision regulations. Cylinders shall not be exposed to sunlight or near heat sources. When opening the bottle valve, the operator must stand at the side of the bottle mouth.
10、 High voltage safety regulations shall be observed during maintenance. The maintenance shall be carried out every 40 hours of operation or every week, every 1000 hours of operation or every six months according to the regulations and procedures.
11、 After startup, manually start the machine tool at low speed in X and Y directions, and check whether there is any abnormality.
12、 After entering the new workpiece program, it is necessary to test run it first and check its operation.
13、 During operation, observe the operation of the machine tool to avoid accidents caused by the cutting machine going out of the effective travel range or collision between two machines.
The above are the basic matters that should be paid attention to in the daily use of the laser cutting machine. In fact, it is necessary to pay attention to many small details and some precautions. Mastering the precautions of the laser cutting machine can not only make the equipment more efficient, but also make it more safe and secure to use.
