It is well known that screw air compressor is one of the auxiliary equipment widely used in metal optical fiber laser cutting machine. The introduction and maintenance steps of the screw air compressor of the laser cutting machine are as follows. Make sure that the power supply of the laser cutting machine has been cut off:
Maintenance steps of optical fiber laser cutting machine (air compressor):
1. Replace the air filter element.
Normally, clean the air cleaner surface every 500 hours.
Check every 2000 hours and replace it.
The inspection or replacement cycle can be extended or shortened according to the dust content
2. Replace the intake valve sealing ring
In the laser cutting machine, if the air compressor works for 4000 hours, check the sealing condition and replace it if necessary.
3. Replace the compressor oil
If you are using a petroleum air compressor.
The oil content shall be checked every 1000 hours, but the engine oil shall be replaced after 4000 hours
4. Clean the oil filter
Replace a new part every 2000 hours.
Otherwise, the oil will affect the cutting effect
5. Clean the oil-gas separator
A new part needs to be replaced every 4000 hours.
For the oil gas compressor, the function of the oil-water separator is to separate the oil in the air from the water in the air, so it will accumulate for a long time and affect the filtering efficiency, without replacing or cleaning the oil-water separator
6. Clean the pressure valve
Clean every 4000 hours and check whether the opening pressure is normal.
7. Check the safety valve
Check every 4000 hours if the operation is sensitive.
8. Check the drive belt
The sealing degree shall be adjusted every 2000 hours, the wear condition shall be checked every 4000 hours, and the replacement shall be determined according to the wear condition.
9. Motor maintenance
Carry out maintenance according to the motor operation manual.
Extended reading: introduction to air compressor of optical fiber laser cutting machine
The importance of air compressor in the field of optical fiber laser cutting machine processing:
The laser cutting machine must use protective gas when processing. Air is a simple and economical air protection gas. Then, what is the function of the air compressor? It is an important equipment for compressed air to enter cutting engineering. The cutting gas composed of high-purity oxygen and nitrogen is supplied to the cutting head. One part is used as the power supply for the cylinder of the clamping table, and the other part is used to purify the optical path system. The compressed air discharged from the air passes through the air receiver, through the dryer, and then enters the air conditioning cabinet. At the same time, the treatment system is transformed into clean and dry gas. Finally, it is divided into three kinds of gas, which are respectively used as cutting gas, cylinder power supply and optical path of positive pressure dust gas to maintain the normal operation of the laser cutting machine.
In short, the air compressor is very important for each metal optical fiber laser cutting equipment. It not only saves cost, but also is easy to operate.
