Using my K40 laser, I was able to make professional looking switch panels. This particular switch panel is going to be installed in our Class A motorhome. I’ll have another video detailing that project.
12″x12″x1/8″ (3mm) Baltic Birch Plywood https://amzn.to/3owmfPR
Dust-Off Disposable Compressed Gas Duster https://amzn.to/3PYXsQf
Delvie’s Plastics Frosted White Sheet (12″x12″x1/8″) https://delviesplastics.com/PROD.html?Product_Code=Frosted_7328_White_Sheet
Rust-Oleum 249127 Painter’s Touch 2X Ultra Cover Flat Black Spray https://amzn.to/3cwVtUC
Delvie’s Plastics black/white laser engrave plastic (1/16″) https://delviesplastics.com/PROD.html?Product_Code=Black_White_9-402
* My preferred material: TroLase (Black/White, 2 Qty x 12″ x 12″ x 1/8″) https://amzn.to/3zxhsDY
Ordered: TroLase Metallic (Brushed Aluminum/Black, 12″ x 20″ x 1/8″) https://amzn.to/3b3nEdH
Ordered: TroLase (English Walnut/White, 2 Qty x 12″ x 12″ x 1/16″) https://amzn.to/3vgJBNh
Settings: Raser Engrave 4mA 100 mm/sec., air assist OFF. Cut 10mA 4 mm/sec, air assist ON. Your settings may vary, so experiment on a small piece before starting a large project.
As an Amazon Associate I earn from qualifying purchases.
UCDaBHY3Lc2X4qMW9DufJYBg
laser engraved
#Laser #Engraved #Switch #Panels #K40 #Laser
