This week, we’ll show you some tips and tricks on laser cutting very thick acrylic. In this video we’ll use our TroGlass Clear 20mm cast acrylic on the SP 500 200w laser cutter.
For those who want a flame-polished edge on clear acrylic they would need to make sure the following steps:
1) Minimal air flow
2) High resolution encoders
3) Longer Focal Length Lenses
4) Focusing to the middle of the material
5) Down draft table that creates a vacuum and draws down the flammable vapor created during the cutting process.
For more of Mike Clarke’s tutorials please visit his website at: http://sublimation.ca
For domestic laser pricing and to set up a demo: https://troteclaser/en-ca/
——————————————————————————————
To get a quote on our laser engraving and cutting machines, please contact us below:
Phone: 1 (888) 998 2217
Email: youtube@troteclaser.ca
Follow us on social media:
Facebook: https://goo.gl/UfHnEa
Twitter: https://goo.gl/GEgTwQ
Instagram: https://goo.gl/gJN5b4
LinkedIn: https://goo.gl/oBL6V4
Trotec Canada locations:
Vancouver | 20381 62 Ave #705, Langley, BC V3A 5E6
Calgary | 820 28 St NE #2, Calgary, AB T2A 6K1
Toronto | 1705 Argentia Rd #9, Mississauga, ON L5N 3A9
Montreal | 8096 Trans Canada Route, Saint-Laurent, QC H4S 1M5
UCRtDslbSIPRUf4JWRg40Q6w
laser cutting for
#Laser #Cutting #Thick #Acrylic #Acrylic #Cutting #Tutorial #Trotec
