As a high-tech product, laser cutting machine has been widely used in the industry. The whole machinery industry needs laser cutting machine for processing. Therefore, for such widely used equipment, how to operate safely has become a public concern. Chuyu Laser will share the usage of laser cutting machine for you.
Chuyu Laser teaches you how to operate the laser cutting machine correctly:
1. Operate the operation manual of the laser cutting machine in strict accordance with the above steps and start the equipment.
2. The operator of the equipment must be trained by the manufacturer of the laser cutting machine before going to work.
3. When processing materials, you must wear necessary protective equipment, such as goggles.
4. Do not use laser to irradiate and handle materials before removal.
5. After the laser cutting machine is started, full-time personnel must be present, and it is forbidden to leave without permission. If it is necessary to leave, turn off the equipment.
6. Fire extinguishers and other equipment shall be available at any time near the laser cutting machine.
7. In the process of processing, if any abnormality is found, the machine should be shut down immediately, and then a special person should be sent for inspection.
8. After using the laser cutting machine, it must be cleaned in time to make full preparation for the next processing.
9. Regularly check the laser tube, auxiliary gas and other consumables. Make sure you have enough!
10. When the laser cutting machine is working, pay attention to observe whether every detail of the machine is abnormal.
How to use the laser cutting machine?
According to the actual situation of the workpiece to be processed, the laser cutting machine selects open or closed processing. Under the condition of avoiding problems, the distance between the nozzle and the workpiece should be as short as possible.
Check whether the feed speed of the electrode wire is appropriate. When cutting the taper, reduce the tension to half of the normal value.
During the processing of the laser cutting machine, it is often necessary to check and monitor the cutting conditions, and deal with the problems immediately after they are found.
During programming, it is necessary to determine the accurate processing technology and processing route according to the actual situation to prevent the workpiece from being scrapped or stuck in advance due to insufficient processing position or insufficient strength of the lapping edge.
When the laser cutting machine starts cutting, please observe and judge whether the processing is normal. If any defect is found, please adjust it in time.
Check whether the tension of electrode wire is sufficient. Before wire cutting, it must be confirmed whether the steps and compensation amount are correct. When moving the worktable or spindle, the moving speed should be accurately selected according to the distance between the workpieces to avoid collision when moving too fast.
Check whether the jet selection is reasonable. Use high pressure jet for rough machining and low pressure jet for finish machining. In close machining, the spacing between the nozzle and the workpiece is usually 0.05-0.1mm.
Safe production is a prerequisite for every enterprise. The correct operation of the laser cutting machine is no exception. Only mastering the normal use of laser cutting machine can create more value for enterprises.
