How to keep the laser cutting machine in good condition? How to maintain the laser cutting machine? The following eight points may help you.
1. To maintain the laser cutting machine, the cooling system must be grounded. Clean the water tank and water circuit regularly. The temperature control point of the cooling temperature control water tank must be appropriate, otherwise the laser tube may be damaged. Condensation may occur, and even worse, the laser power will be reduced. Cold water may fall off. Therefore, we will greatly shorten the service life. At the same time, it sometimes fails to work properly, which leads to continuous replacement of pipes.
2. To maintain the laser cutting machine, please correctly install the laser pipe fulcrum of the laser cutting machine. The fulcrum shall be 1/4 of the total length of the laser tube. Otherwise, the spot pattern of the laser tube will deteriorate. Sometimes the light spot will become several points in a period of time, which will reduce the laser power. Therefore, the requirements cannot be met.
3. In order to keep the laser cutting machine in good condition, always check and clean the waterproof device.
How to maintain the laser cutting machine?
4. Regularly check and clean the dust suction device, and clean the fan duct. Otherwise, a large amount of smoke and dust will not be discharged. This will contaminate the lens and the laser tube. Therefore, mechanical and electronic parts are easy to be oxidized and lead to poor contact.
5. Focus the lens and reflector, and the rear mirror frame will become hot after a period of time. The lens surface will change color and rust. When peeling and cracking occurs, we must replace the object. Especially many customers use air pumps and air compressors, so the focusing lens is easy to cause water accumulation on the surface. Therefore, it is necessary to regularly ensure the cleanliness and quality of the lenses in the optical system.
6. Ensure that the working environment of the machine is good. The working environment of the laser cutting machine should not be too harsh. For example, the ambient temperature is above 30 degrees and below 18 degrees. Excessive dust and serious air pollution. This will cause damage to the machine and the failure rate will continue to increase. Electrical accessories in wet environments are prone to errors.
7. We need to correctly match the power supply of the laser cutting machine.
8. The working current of the laser tube must be reasonable. It cannot work at full power for a long time. We must use the laser properly and preserve it. The optical system should be cleaned regularly, otherwise the laser tube will age and break prematurely. During operation, adjust the power of the laser equipment to 50-60% of the total power. Then adjust the working speed according to the material, which is the best working state of the laser tube.
