With the rapid growth of production and consumption of China’s metal industry, sheet metal processing technology has also been developed rapidly, especially the advent of laser cutting machine, which has brought unprecedented leap for sheet metal processing.
How to adjust the laser cutting machine to make it cut faster and better?
In fact, both machines and personnel need regular maintenance to maintain relatively good operating conditions. In fact, there are many ways to adjust the slow cutting or poor cutting of the machine. Today’s editor will introduce several methods to improve the cutting effect and speed of laser cutting machine.
First, adjust the parameters of the laser machine to improve the cutting speed.
How to adjust the laser cutting machine
Machine parameter setting is one of the main reasons that affect the cutting speed of the machine. Generally, if the parameters are not adjusted properly, the cutting speed will be poor. Parameters are like actions related to a series of actions (such as driving, starting, accelerating, etc.). If the parameter settings are incorrect, just like when the car starts, it will shake when you shift to the second gear. Start.
When adjusting this parameter, pay attention to the following points:
1. Initial speed: As the name implies, this setting is the starting speed of the machine, such as the starting speed of the car during driving. Many customers mistakenly believe that the greater the initial speed, the better, but in fact this is wrong. If the initial speed of the laser machine is set too high, the machine jitter will be very large.
2. Acceleration: acceleration refers to the speed of fuel valve during driving. This is the time from the initial speed to the normal cutting of the machine. When the machine cuts different patterns, it is a process of continuous starting, stopping and stopping. If the acceleration is set too low, the cutting will slow down.
Secondly, adjust the machine assembly to improve the cutting effect.
1. Installation of guide rail: the installation of guide rail shall be parallel. If the installation is not parallel, there will be resistance when the machine is running. If it gets stuck when walking, there will be sawtooth when cutting. Therefore, only two parallel lines can be installed on the two Y direction rails, and there should be no error between them.
2. The installation position of cross beam and coupling is not good. When installing the machine beam and coupling, the screws are not locked, or the locking is inclined.
Therefore, in the daily use of the laser cutting machine, the precautions must not be ignored, and the laser cutting machine should also be maintained regularly, so that the equipment can run for a longer time.
