A very important client asked me to make a commemorative plaque out of a slab of red oak. In this video I will show you the process of cleaning up the wood, laser engraving, and finishing with marine varnish. I hope you enjoy!
Laser engraving wood is a fun process that can be very rewarding. I set up the engraving using Lightburn, then engraved using the Sculpfun S9 Laser Engraver.
Support on Patreon
https://patreon.com/madmarewoodworks
Music: Acoustic Breeze by BenSound
***** Laser Engraver & Finish *****
Sculpfun S9 Laser Engraver: https://amzn.to/3zrsVnB
TotalBoat Marine Varnish: https://amzn.to/3J5UdEi
Minwax Pre-Stain: https://amzn.to/3PyuKWD
Minwas Gel Stain: https://amzn.to/3PF7FRZ
***** Tools I Recommend******
Table Saw: https://amzn.to/3rQheDS
Miter Saw: https://amzn.to/3vBsxAE
Circular Saw: https://amzn.to/3KwrR4Z
Jig Saw: https://amzn.to/36RceHS
Drill/Driver Set: https://amzn.to/3vRv5Ld
Hammer Drill: https://amzn.to/3EXAEMg
Sander: https://amzn.to/38w9mAw
Shop Vac: https://amzn.to/3y1sCAs
Dust Cyclone: https://amzn.to/37Sa3Em
Air Filter: https://amzn.to/3EVIw0I
Tape Measure: https://amzn.to/3OAX0HS
Speed Square: https://amzn.to/3KeTdg3
Router: https://amzn.to/3xT01NR
***** Camera Gear ******
Camera: https://amzn.to/3ENUx8t
Microphone: https://amzn.to/3OzVpC5
Tripod: https://amzn.to/3MvVZim
Lights: https://amzn.to/3ETMAP9
Aputure LED Light: https://amzn.to/3Kao9xP
SD Card: https://amzn.to/3KglPp5
UCaHN-5kAv3ie5yjsc18yelw
laser engraved
#Laser #Engraved #Plaque #Sculpfun #Laser #Engraved #Wood #Slab
