The Atomstack X7 Pro is a new flagship diode laser cutter and engraver. How does it stack up against the competition from Ortur and xTool? Let’s dive into this pretty impressive machine!
Note: I mentioned exact prices in this video, but those tend to fluctuate a good bit, so be sure and check them below. Normally Atomstack is a little bit MORE expensive than Ortur, I switched that a few times in the video.
🧪 Download My Lightburn Test Files:
Atomstack X7 Pro –
Ortur Laser Master Engraver 2 Pro –
xTool D1 –
Ortur Aufero –
TIMESTAMPS
00:00 – Assembly
01:15 – General Build Quality
03:47 – Touchscreen
05:37 – Safety
06:41 – Materials you can use
07:13 – Drawback
08:09 – 10W Laser
10:34 – Performance Tests
14:57 – Comparison to Ortur
16:49 – Comparison to xTool D1
17:10 – Recommendation
—
💵Support the channel on Patreon:
🎙Listen to the podcast (Make or Break Show):
🌄Daily updates on Instagram:
🤖FAVORITE ROBOTS (affiliate)
Favorite Laser Cutter –
Budget Diode Laser –
Budget CO2 Laser –
Engrave Metal –
X-Carve CNC –
Favorite 3D Printer –
Resin 3D Printer –
Vinyl Cutter –
🛠️TOOLS (affiliate)
Table Saw –
Miter Saw –
Band Saw –
Impact Drive & Drill –
Drill Press –
Planer –
Orbital Sander –
6 in Jointer –
Welder –
Kreg Jig K4 –
Plunge Router –
Jack Handplane –
Combo Square –
Woodpeckers 6 in Square –
PFEIL Marking Knife –
Handsaw –
📹 CAMERA GEAR (affiliate)
Main Camera –
All Around Lens –
On Camera Microphone –
Rode Wireless Kit –
Diety Lav Mic –
Tripod –
Video Switcher –
Key Light –
🎙PODCASTING GEAR (affiliate)
Microphone –
Cheaper Microphone –
Audio Interface/Recorder –
Cheaper Interface –
Make or Break Shop
#Cheaper #Atomstack #Pro #Laser #Engraver #Review
