What are the reasons for the sudden automatic reset of the laser engraving machine during engraving processing, which automatically returns to the mechanical origin, or the phenomenon of stopping, missing, and disorderly engraving in the middle of engraving? How should we solve it?
Laser engraving machine, which automatically resets during operation, stops engraving midway, misses engraving and causes engraving failure analysis:
The main reasons for the above are loose control panel and network cable connections, unreliable motherboard and grounding wires, or slight high-voltage ignition faults.
resolvent:
1. Check the grounding condition of the equipment and measure whether the grounding wire meets the standard (the resistance to ground should not exceed 5 ohms). If it does not meet the standard, the grounding wire needs to be changed until it meets the standard.
2. Connect the network cable to check for looseness, poor contact of the control panel buttons, or interference from strong electricity and magnetism in the location of the device.
3. Check if the computer has set up a screen saver or power saving mode (such as hibernation or shutdown), just cancel the above settings and change them to never.
4. Check if there are any errors in the original graphics, such as crossing, unclosed, missing strokes, etc. Change the graphics to output for testing. For example, when outputting with Wentai software, check if the path calculation is normal and need to register or install Wentai software again or reinstall the system.
5. If there is a problem with the graphics format output, there will be graphics errors, and you need to re output or remake the graphics.
6. Check if there is any ignition on the laser tube or laser power supply.
