The dimming path of laser cutting machine is a headache for many people. Today, I will tell you about the dimming path of laser cutting machine.
Laser cutting is to gather the laser beam into a small spot through the focusing mirror and project it onto the metal surface, and the focal point reaches a high power density. At this time, the irradiated part of the material is quickly heated to the vaporization temperature, and evaporates to form a hole. It moves linearly relative to the material, so that the hole continuously forms a narrow slit, so as to achieve thexc purpose of cutting the material.
First, adjust the power to about ten percent, then turn off the laser, and then adjust the light.
First stick the scotch tape on the reflector and shoot it to confirm whether the light is in the middle of the reflector, then adjust the three rotating screws on the reflector to adjust the light to the center of the lens barrel, and finally install the laser nozzle and shoot it again. Whether it is in the center of the laser nozzle.
Correct the laser vertical
First adjust the laser power to about 40%, use an organic board to confirm whether the upper and lower lights are vertical, and if they are vertical, perform alignment.
If it is on an organic board, the height of the laser tube can be adjusted obliquely forward and backward, and the bracket of the laser tube can be tilted left and right to swing left and right.
Lighting: After confirming the focal length of the upper and lower laser heads, loosen the screws on the right and front of the upper laser head to adjust.
Use the board to cut the field shape, and adjust the width of the knife seam and the verticality of the board.
